Select all of the statements that are true for using the Digital Multi-meter: Group of answer choices For voltage and resistance measurements the test leads are placed in the same connections, common (or -) and V (also Ω). There is a no difference between the DC and AC Voltage setting. To measure resistance the dial must be set to Ω. To measure DC voltage the dial must be set to V DC. It’s OK to measure resistance with the circuit powered. You will get the correct measurement for resistance if the resistor is measured in a circuit.

1. For voltage and resistance measurements the test leads are placed in the same connections, common (or -) and V (also Ω) because the voltage remains same in parallel connection

2. To measure resistance the dial must be set to Ω

because the SI unit of resistance is Ω. Hence, it is to be measured in Ω

3. To measure DC voltage the dial must be set to V

because the SI unit of voltage is Volts denoted by V

codiepienagoya codiepienagoya · Answer 2 · 2022-02-24T14:54:25+01:00

Following are the solution to the given points:

AC/ DC Voltage:

It's indeed correct since, to measure voltage and resistance in a multimeter, you must first establish a voltage source by connecting a phase wire to the (+) terminal as well as a common terminal to the negative end, or ground.

It was not a fact, Since you must specify what you want to measure to measure AC or DC voltage.

True, the impedance dial should be set to ohms to be used to measure resistance.

True, the dial must be set to V to measure voltage.

It is false because it demonstrates an inaccuracy in the analogous circuit caused by a voltmeter's internal resistance.

When a resistor is connected to a circuit, this assertion is true.

Find out the more information about the Voltage here:

brainly.com/question/17270682