Question

4. A meter has a resistance of 100 Ω and gives a full scale deflection when it carries a current of 25 μA. (a) What resistor, Rx, would you connect in parallel with this meter in order to construct an ammeter which gives a full-scale deflection for a current of 50 mA? (b) What is the equivalent resistance for this ammeter?

Answer 1

Answer:

A=50mΩ

B≅50mΩ

Explanation:

A) To answer this question we have to use the Current Divider Rule. that rule says:

$Ix=.\frac{Req}{Rx} *Itotal$ (1)

Itotal represents the new maximun current, 50mA, Ix is the current going through the 100 ohms resistor, and Req. is the equivalent resitor.

We now have a set of two resistor in parallel, so:

$Req.=\frac{1}{\frac{1}{R1}+\frac{1}{R2}  }$ (2)

where R1 is the resitor we have to calculate, and R2 is the 100 ohms resistor (25 uA).

substituting and rearranging (2)

$Req.=\frac{ 100*R1}{R1+100}$ (3)

Now substituting (3) in (1).

$25*10^{-6} =\frac{\frac{ 100*R1}{R1+100}}{100} *50*10^{-3}$

solving this, The value of R1 is: 50mΩ

This value of R1 will guaranty that the ammeter full reflection willl be at 50mA.

Given that R2 (100ohm) it too much bigger than 50mΩ, the equivalent resistor will tend to 50mΩ

If you substitude this values on (2) Req. will be 49.97 mΩ.