you are working at the command line and want to add the read-only attribute to a file and remove the hidden attribute. which command would you use?

Question

26-10-2022
Computers and Technology

contestada

you are working at the command line and want to add the read-only attribute to a file and remove the hidden attribute. which command would you use?

Respuesta :

Otras preguntas

A list of measurements in increasing order is 4, 5, 6, 8, 10, and x. If the median of these measurements is 6/7 times their arithmetic mean, what is the value o

The minute hand of a clock is 4.7 cm long. Calculate the are of the sector swept by the minute hand after 25 min

The following data have been recorded for recently completed Job 323 on its job cost sheet. Direct materials cost was $2,057. A total of 37 direct labor-hours a

What factors underlay the decision by Volkswagen to invest directly in automobile production in Russia? Why was FDI preferable to exporting from existing factor

Jim left his previous job as a sales manager and started his own sales consulting business. He previously earned $70,000 per year, but he now pays himself $25,0

Some people who have narcolepsy experience a sudden loss of muscle tone, a condition called ________. This can be very dangerous, as a person can hurt themselve

What's 4 to the 9th power

A boat is heading due north across a river with aspeed of 12.0 km/h relative to the water. The water inthe river has a uniform velocity of 6.00 km/h due eastrel

The term _________________ is used by a beneficiary to cover healthcare services that are not covered by Part A or B. These policies must meet federally imposed

how is the answer C?

ACCESS MORE EDU ACCESS Universidad de Mexico

rekharaypriti8910 rekharaypriti8910 · Answer 1 · 2022-10-30T10:02:44+01:00

To add the Read-only attribute and remove the Hidden attribute, use attrib +r -h. To remove the write protection on the chosen drive, enter "attributes disk clean read only" and hit "Enter".

At the Command prompt, enter the command attribute -r +s "drive :path folder name" (be sure to include the drive letter, entire path, and folder name). By using this command, the file's read-only attribute will be removed and replaced with a system attribute. Restart the computer and click the F5 key when you see the message "Starting MS-DOS" or the MS-DOS version if the computer is unable to load MS-DOS. The MS-DOS default settings should be loaded by pressing this key.

Learn more about command here-

https://brainly.com/question/14583083

#SPJ4