Question

The 2960 switches have been taken out of the box and cabled, and PC2 can communicate through R1 with the rest of the IP network. However, no configuration has been added to either SW1 or SW2. As a result, the network engineers sitting at a management station to the right of R1 cannot ping or telnet to SW2. Required:
What configuration commands, when entered in the correct order on SW2, allow the network engineer to ping or telnet to SW2 from the management station?

Answer 1

The correct order of configuration commands on switch 2 (SW2) that would allow the network engineer to successfully ping or telnet to SW2 from the management station are:

1. Enter IP address of switch 2 (SW2).
2. Set IP default-gateway.
3. Configure interface VLAN 1.
4. No shutdown

What is a command?

A command can be defined as a set of instructions that are typically used to configure a network device such as a switch, so as to make it active on a computer network and enable it perform certain tasks automatically during network communication.

In Computer networking, commands can be used to ensure the interfaces (ports) on a switch are active and open for connections from other network devices such as:

• Routers

• Workstations (computers)

In this scenario, the network engineer should use the following configuration commands on switch 2 (SW2), so as to successfully ping or telnet to SW2 from the management station are:

1. Enter IP address of switch 2 (SW2).
2. Set IP default-gateway.
3. Configure interface VLAN 1.
4. No shutdown

Read more on a switch here: https://brainly.com/question/13243868